Filter
Top Products
Return flow sensor (RüF2)
Solar circuit collector sensor (CF)
Flow sensor (VF2)
Storage tank sensor (SF1–SF2)
Flow sensor in DHW circuit (VF3)
Activate editing mode for sensor.
Correct measured temperature.
Read the actual temperature directly from the thermometer at the point of measure
-
ment and enter this value as the reference temperature.
Confirm corrected measured temperature.
Additional sensors are calibrated similarly.
Exit the configuration level.
Return to the operating level.
2.6 Resetting to default values
All parameters and function blocks from any parameter level can be reset to their default set-
tings (WE).
Proceed as follows:
Reset to default settings.
Function blocks and parameters are reset to their default settings (WE).
Note!
Resetting protected parameters to their default settings is only possible when the key number is
still active. The function block settings are kept.
Note!
The controller is ready for operation with its default settings. You just need to setthe correct date
and current time.
EB 5476 EN 21
Start-up