Filter
Top Products
Quadra-Fire • QFP44 • 4051-300 Rev M • 09/0854
• Install the upper back refractory.
Figure 14.4 Install Upper Back Refractory
• Install the right side refractory.
• Slide the back refractory slightly from side to side as
necessary to close up any gaps in the corners.
• Install the right side refractory retainer.
Figure 14.5 Install Right Side Refractory
Note: As you use the appliance, expansion and contraction
will cause minor cracking of the refractory. This is normal,
unavoidable, and will not affect the performance of the
appliance. If the cracks become large enough that the
metal behind the refractory is exposed or large pieces
fall out, the panels should be replaced.
IMPORTANT! This appliance should be run
three to four hours on low on the initial start-up.
Turn it off and let it cool completely. Remove and
clean the glass. Reinstall the glass and run the
appliance for an additional 12 hours. This will help
cure the products used in the paint and logs.
Figure 14.6 Adjusting the Air Shutter
D. Adjust the Air Shutter
This appliance has adjustable air shutters (which control
the primary air) factory set in the closed position (approxi-
mately 1/8 in. open). See Figure 14.6.
NOTICE:
If sooting occurs, provide more air by opening
the air shutter.