Filter
Top Products
Quadra-Fire • QFP44 • 4051-300 Rev M • 09/0816
H. Before Lighting Fireplace
Before operating this replace for the rst time, have a
quali¿ ed service technician:
• Verify all shipping materials have been removed from
inside and/or underneath the rebox.
• Review proper placement of logs, rockwool and/or other
decorative materials.
• Check the wiring.
• Check the air shutter adjustment.
• Ensure that there are no gas leaks.
• Ensure that the glass is sealed and in the proper position
and that the integral barrier is in place.
WARNING! Risk of Fire or Asphyxiation! DO NOT oper-
ate ¿ replace with ¿ xed glass assembly removed.
• Advance the SET temperature on the transmitter to a
temperature of at least 2° F (1° C) above the ROOM
temperature displayed on the LCD screen and the
system ame will ignite.
• Set the SET temperature to at least 2° F (1° C)
below the room temperature and the system ame
will extinguish. Thereafter, it should continue to cycle
on and off thermostatically approximately every two
minutes as the ROOM temperature changes, but only
when the temperature differential between ROOM and
SET temperatures differs at least 2° F (1° C). The 2° F
differential is the factory setting.
Timer Operation
The countdown timer will operate in either the manual ON
or THERMO mode. Once the replace system is in an
operating mode, set the countdown timer to turn off in 15
minutes. The timer function will allow operation to contin-
ue until the “countdown time” on the LCD screen expires.
After 15 minutes elapse, the system should turn off.
General Information
Transmitter Wall Bracket
The transmitter can be hung on a wall using the bracket
provided. Locate the bracket on an inside wall suf ciently
far away from direct sources of heat such as a replace,
incandescent lighting, or sunlight so it detects ambi-
ent room temperatures, not a single heat source. If the
bracket is installed on a solid wood wall, drill 1/8” pilot
holes and install with the screws provided. If it is installed
on a plaster/wallboard wall, rst drill two 1/4” holes into
the wall, then use a hammer to tap in the two plastic
wall anchors ush with the wall, then install the screws
provided.
Battery Life
Life expectancy of the batteries in the transmitter should
be at least 12 months. Check batteries annually. When
the transmitter no longer operates the remote receiver
from a distance it did previously (i.e., the transmitter’s
range has decreased) the batteries should be checked.
Speci¿ cations
Batteries: Transmitter - 3V 2 ea.; AAA 1.5V, Alkaline
Remote - 110-120 VAC; 60Hz
Operating Frequency: 303.8 MHZ
FCC ID No.’s: Transmitter - K9L300ITX
Receiver - K9L3003RX
Canadian ISC ID No.’s: Transmitter - 2439 102 760
Receiver - 2439 102 760A