Filter
Top Products
Quadra-Fire • QFP44 • 4051-300 Rev M • 09/0810
Clear Space
3 ft (0.91 m)
in front of
appliance
C. Clear Space
WARNING! DO NOT place combustible objects in front of
the ¿ replace or block louvers. High temperatures may start
a ¿ re. See Figure 2.2.
Avoid placing candles and other heat-sensitive objects on
mantel or hearth. Heat may damage these objects.
Figure 2.2 Clear Space
E. Fixed Glass Assembly
See Section 14.A.
D. Decorative Doors and Fronts
WARNING! Risk of Fire! Install ONLY doors or fronts
approved by Hearth & Home Technologies. Unapproved
doors or fronts may cause ¿ replace to overheat.
This appliance requires the installation of a decorative front
with an integral barrier to prevent direct contact with the
¿ xed glass panel. Do NOT operate the appliance with the
barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install
one.
For more information refer to the instructions supplied
with your decorative door or front.
F. Dashboard Control
Figure 2.3 Dashboard Control
Valve Control
This knob is used to control the gas to the appliance and
for starting the pilot. There are three positions, ON, OFF,
PILOT. The indicator on the valve indicates the position of
the knob.
Pilot Ignitor
This unit is equipped with an electronic ignitor for the
pilot. When the valve control knob is turned to the PILOT
position and fully depressed, the ignitor will begin spark-
ing and light the pilot. After the pilot is lit, release the
knob slightly to stop the ignitor from sparking but continue
holding the knob in for 30 seconds to establish the pilot.
Release the knob and the pilot should stay lit.
Rear Burner Switch
The rear burner can be shut off completely with the
switch, allowing the front burner to operate in either high
or low mode for limited heat output.
Î