Filter
Top Products
Appendix A: eFamily Update Utility (Backup, Upgrade, And Restore eFamily Device Software)
30
Intelli-M Hardware Installation And Reference Guide
Installing The eFamily Update Utility
Installation of the eFamily Update Utility is dependent on Intelli-M
®
Supervisor Plus or the
Intelli-M
®
Web Interface.
Note: The Supervisor Plus software has not been UL verified.
Supervisor Plus Users
The eFamily Update Utility can be found on the Intelli-M Supervisor Plus installation CD. Once
the CD is placed into the CD-ROM drive, right-click on the CD-ROM drive icon within “My
Computer” and select “Open.” Navigate to the eFamily Update Utility folder, and then follow the
installation procedure steps below.
Web Interface Users
The eFamily Update Utility file can be downloaded from the Pelco Web site at: www.pelco.com.
Installation Procedure
The procedure for installing the eFamily Update Utility is as follows:
1. If the file was downloaded from the Web site, unzip the downloaded file.
Important: Make a note of where you unzip the file contents, as you will need the unzipped
files during the update procedure.
2. Launch (double click) the “setup.exe” file.
The welcome screen for the install wizard screen similar to that shown in Figure A-1 will
be displayed.
Figure A-1: Setup Welcome Screen
3. Click the “Next” button.
The installer select installation folder screen similar to that shown in Figure A-2 will be
displayed.