Filter
Top Products
5
PART 2 HARDWARE
2.1 Wall Mounting
Position unit where required. Mark and drill the two #4 screw holes.
After bracket is mounted on the wall, align back of unit over the three bracket clips, once
engaged, slide downward, the unit will snap in place.
For extra security, you may screw the unit onto the bracket. Remove cover (see Section
2.4) and screw a #4 x 1/4” long self-tapping screw through the case and bracket.
Figure 2.1 Mounting
0.59 [14.9]
1.81 [46.1]
1.50 [38.1]
5.13 [130.2]
1.50 [38.1]
0.24 [6.1]
0.94 [23.8]
3.47 [88.1]
1.36 [34.4]
REAR WIRE
ENTRY AREA
ADDITIONAL MOUNTING OPTION-
TO RETAIN UNIT TO MOUNTING BRACKET
USE #4 X 1/4" LONG SELF-TAPPING SCREW
DRILL 0.125 [3.17]
USE TWO, #4
FLAT HEAD SCREWS
TO MOUNT BRACKET
UNIT OUTLINE
CLIPS (3)
It is recom-
mended that
you ground your
unit by wrapping a wire
around the case’s
bottom screw or
by
connecting a wire to
the Return/Ground
position of the relay
connector (see Figure
2.8 and 3.1).
Figure 2.2 Dimensions