Filter
Top Products
37
4.5.2 HTTPget and ARP to setup Device IP Address
Use the iConnect software, which may be downloaded from our website, to do
these IP changes whenever possible.
Use ARP first to assign the mac address to a static IP address in computer arp table by
this command:
arp –s 192.168.1.200 00-03-34-00-06-b6
Then use the following command to assign new IP to the device:
httpget –r –S "00000000" 192.168.1.200:1
where:
“00000000” is admin. password. If the password is wrong, the unit will ignore the new IP.
If the new IP is taken, you will get the message " New IP is Assigned" after the HTTPget
command. The device will reset automatically. (TX and RX led is on for 2 seconds).
“192.168.1.200” is an example of an IP adress. It is replaced with an IP address suitable
for your network
“00-03-34-00-06-b6” is replaced with your iSE product MAC address.