Filter
Top Products
2.8 Running on Battery Power
To access the Battery and S5 jumper you must remove the cover, refer to Section 2.4.
When you first connect the battery, without the AC power adaptor, the unit will be in “Sleep
Mode”, in order to save power, and the LCD will display “Flash Standby” (provided that S5
jumper is not installed). When battery is installed, plug the AC adaptor into unit and push the
Flash Reset Button (refer to Figure 2.4). Unit is now ready to be configured for recording the
data. Also, if the AC adaptor is unplugged while the unit is recording, the battery will take
over and recording will continue.
Battery and S5 jumper installed
: if there is a power outage the iSE board will be fully
functional including Ethernet and the LCD backlight “ON”, for approximately 1 hour.
You need to make sure that the LCD/PWR field on the Configuration page of the iSE is set to
UPS (see Section 4.3.5.F)
Battery installed and S5 jumper in storage position (Factory Default of S5)
: if there is a power
outage the LCD Backlight and Ethernet will not run, but
the unit will be collecting and storing
data for approximately 10 days.
If you want to move the unit to a different location, remove the AC adapter; the
installed battery will keep the recording alive until the AC adapter is plugged
back in.
Figure 2.9 Battery and S5 Jumper Location
KEEP INSULATOR COVER
ON BATTERY CLIP
WHEN BATTERY IS NOT
BEING USED
TRAY
REMOVE BATTERY CLIP
INSULATOR COVER AND
STORE AGAINST BATTERY
WHEN BATTERY IS BEING USED.
S5 PINS
INSULATOR COVER
9VDC BATTERY
10
10