Filter
Top Products
24
4.3.4 Access Control
This section describes the "Access Control" page of the iSE’s Web interface. This page
allows the users to set up the network and security parameters of the iSE.
At the initial entrance to the “Access Control” page you will be prompted for the LOGIN
Password (see Figure 4.6) prior to an ADMINISTRATOR Password.
Figure 4.10 Access Control
Login Password: This allows users to access and modify all of the iSE Home Page menu
items, except “Access Control”, which requires an Administrator password. The default
Login password is 12345678. This password can be up to 16 alpha-numeric case-sensitive
characters. If there is no Login Password assigned (blank box) the iSE will not require a
password to access and modify iSE Home page menu items.
Admin (administrator) Password: This allows users to access and modify the "Access
Control" page. The default password is 00000000. This password can be up to 16 alpha-
numeric case-sensitive characters. If there is no Administrator Password assigned (blank
box) the iSE will not require password to access and modify "Access Control" page.
Host Name: Refer to Section 3.4, DNS.
MAC Address: This is also called Hardware address or Ethernet address, which is
assigned to the iSE at production. The MAC (Media Access Control) address is the iSE’s
unique hardware number and is not changeable.
IP Address: The IP (Internet Protocol) address is a 32-bit number that identifies each sender
or receiver of information that is sent in packets across the Ethernet or the Internet. The iSE’s
default IP address is 192.168.1.200. The iSE’s IP address should be changed to fit user’s
networking environment. Consult with your IT department for obtaining an IP address.
Gateway Address: A gateway is a network point that acts as an entrance to another
network. A gateway is often associated with a router, which knows where to direct a given
packet of data that arrives at the gateway. If the iSE is sending packets to another network
node that is not on the same network on which the iSE is connected, a gateway address
needs to be given to the iSE. The gateway address should be the IP address of the router
connected to the same LAN to which the iSE is connected. The iSE’s default gateway
address is 0.0.0.0. Consult with your IT department for obtaining a gateway address.
Subnet Mask: It is a 32-bit number that is used to determine which part of the IP address
is the network portion and which part is the host portion. The iSE’s default subnet mask is
255.255.255.0. Consult with your IT department for obtaining a subnet mask.
Camera IP: If there is a networked camera on the LAN, it can be accessed from the iSE’s
Home Page by adding the Camera’s IP address in this field.
ACCESS CONTROL
ACCESS CONTROL
http://192.168.1.200
Address
Main Menu
Login Password: 12345678
Admin Password:
00000000
IP Address: 192.168.1.200
Camera IP: 0.0.0.0
Gateway Address:
0.0.0.0
Camera Label:
Camera Location
Subnet Mask:
255.255.255.0
MAC Address: 00:03:03:00:21:D9
Host Name: eis21d9
Save Reset
Power Recycle
The DHCP can be enabled by
setting the dip switch number 3
to ON position.
Changes made in the iSE’s
Access Control page can be
saved permanently by pressing
the Save button and power
recycling the iSE.
If you change a field and press Save,
this message will appear
Click the following button to activate the new settings.