Filter
Top Products
PART 1
INTRODUCTION
1.1 Safety and EMC Considerations
Refer to the CE Approvals Section.
EMC Considerations
• Whenever EMC is an issue, always use shielded cables.
• Never run signal and power wires in the same conduit.
• Use twisted-pair wires for signal connections.
• Install Ferrite Bead(s) on signal wires close to the instrument if EMC problems persist.
Failure to follow all instructions and warnings may result in injury!
1.2 Before You Begin
Inspecting Your Shipment: Remove the packing slip and verify that you have received
everything listed. Inspect the container and equipment for signs of damage as soon as
you receive the shipment. Note any evidence of rough handling in transit. Immediately
report any damage to the shipping agent. The carrier will not honor damage claims
unless all shipping material is saved for inspection. After examining and removing the
contents, save the packing material and carton in the event reshipment is necessary.
Customer Service: If you need assistance, please contact the Customer Service
Department nearest you.
Manuals, Software: The latest Operation Manual as well as free configuration software
(iConnect), datalogging software (iLog), download utility (iFlash), and Mail Notifier are
available at the website listed on the cover page of this manual or on the CD-ROM
enclosed with your shipment.
1.3 Description
Web-based Remote Surveillance of Temperature and Security
The iSE environmental monitor provides Web-based remote surveillance of
environmental conditions in critical HVAC applications such as computer server rooms,
clean rooms, laboratories, museums, warehouses, or any remote facility. View and
record Temperature on two independent thermocouple channels, over an Ethernet
network or the Internet with no special software—just a Web browser.
EMAIL ALARMS -- The device can trigger an alarm if temperature goes above or below
a set point that you determine. Your alarm can be sent by email to a single user or to a
group distribution list, including text messages to cell phones and PDA’s.
PHYSICAL THREATS -- The iSE includes screw terminals for two contact closures that
work with common alarm sensors. You can instruct the iSE monitor to send an alarm if a
door is opened, a window is broken, or a fire sprinkler goes off.
POWER FAILURE -- The iSE monitor can trigger an alarm if the AC power fails. The
iSE monitor will continue to collect data for ten days powered by a standard 9 Volt
alkaline battery (included). The data is stored in nonvolatile flash memory and can later
be downloaded over the Ethernet.
2