Filter
Top Products
Optional Equipment (for qualified installers only) 65
© Travis Industries 4070201 100-01182_002
4 Install the strain relief plate to the firebox floor following the directions below.
=
a
b
Insert the four wires through the
strain relief plate (
NOTE: Put the
larger, male connectors through
first).
Secure the wires using the included strain relief
(wrap the strain relief over the wires, compress
with pliers, then insert into the hole).
Secure the strain relief plate
to the firebox floor with the
screws removed earlier.
Route the wires behind the pilot
assembly. There are two small tabs on
the pilot bracket that can be bent down to
secure the wiring. All wiring must be
secured away from the burner.
c
d
5 Restore the firebox to the correct configuration (replace the burner, firebacks, logs).
If using the optional wall-mounted rheostat, follow the directions on the following page "Wall Mounted
Rheostat".
6 Install the rheostat assembly following the directions below.
a
Attach the rheostat assembly to the
fireplace with the included screws.
Attach the quick-connects from the
rheostat to the quick-connects from
the accent light assemblies
(orientation does not matter). Plug
the rheostat into the receptacle.
b