Filter
Top Products
Optional Equipment (for qualified installers only) 63
© Travis Industries 4070201 100-01182_002
2 Follow the directions below to wire the rheostat. NOTE: There are two types of junction boxes,
use the appropriate junction box for your installation.
a
Force the sheathed cable through
one of the locking flaps on the
junction box (repeat for the other
cable). Some force is needed.
The flap will lock the cable in place.
Attach the cover plate
(either white or beige) with
the included screws. Slide
the knob (either white or
beige) over the rheostat
shaft.
Attach the common (white) wires
together. Attach the ground
(exposed or green) wires together.
Then attach each of the hot (black)
wires from the cables to the two
wires on the rheostat (orientation
does not matter). Carefully pack
the wires into the junction box.
c
b
From
Blower Box
To Fireplace (36DV & 44 DV)
To Power Supply (864TRV)
Standard
Screwdriver
NOTE:Two junction
boxes are included -
use the best box for
your installation.
3 Run the free wire from the rheostat junction box to the power supply. The thermodisk included
with this kit may be discarded (it is not used on this fireplace).
Operating Instructions
Allow the fireplace to reach normal operating temperature. Then use the wall-mounted rheostat to
operate the blower speed.
864TRV: Turn the blower off when the fireplace is not in operation.
OFF
Turn the dial all
the way counter-
clockwise until it
clicks off.
HIGH
The high position is
all the way counter-
clockwise, without
clicking off.
LOW
Turn the dial
all the way
clockwise.
MAINTENANCE INSTRUCTIONS
Once a year the grill should be
removed and the blower area
cleaned. Use a vacuum to clean
around the squirrel-cage blower,
being careful not to damage any
of the blades.
Grill
Phillips
Screwdriver
Use a vacuum cleaner to remove
any debris from the power vent
blower.