Filter
Top Products
64 Optional Equipment (for qualified installers only)
Travis Industries 4070201 100-01182_002
Accent Light Installation (sku 94400100)
Make sure power to the fireplace has been turned off prior to installation (disable the service breaker).
Do not connect 110-120 VAC to the gas control valve or the on/off circuit on this fireplace.
The accent light must be removed to install the rear fireback. The remaining firebacks are installed after
the accent light is in place.
1 Remove the firebacks (if already installed – see page 47). Remove the burner (see 52 for
details).
2 Remove the cover plate following the directions below.
Cover Plate
3 Place the rear fireback in position and install the accent light assemblies following the
directions below.
Accent Light Assemblies
Magnetic Nutdriver
Magnetic Nutdriver
Rear Fireback