Filter
Top Products
Optional Equipment (for qualified installers only) 57
© Travis Industries 4070201 100-01182_002
Extra Room Power Heat Duct (sku 98500769)
Special Instructions for 864 HH
Newer 864 HH fireplaces (SN 3407-001010 or greater) have an improved wiring harness and
removable heat shields below the heat duct connections. The wiring harness is now routed through
the snap disk, allowing the power heat duct to be turned on and off by the fireplace (see “Wiring
Instructions” on page 62). An additional knock-out was added to the fireplace to allow for the
electrical line to be routed to the power heat duct (see below). The removable heat shields allow
more heat to be routed to the power heat ducts (see below for details).
New Wire Hook-Up
A knock-out is provided on the left side of the fireplace for
routing the sheathed cable (romex) from the inside of the
firebox to the power heat duct. Use the strain relief
(included with the power heat duct) to secure the cable.
Cable to
Power Heat
Duct
Molex Connector (included with heat duct
kit) - use wire nuts to attach to the cable.
Molex Connector
(attached to the
wiring harness on
the fireplace)
New Removable Heat Shield (improves heat output to power heat duct)
Remove and discard the power heat
duct cover plate (one or both sides).
Remove and discard the circular cover
plate attached to the heat shield.