Filter
Top Products
60 Optional Equipment (for qualified installers only)
Travis Industries 4070201 100-01182_002
Floor Mounting
Cut a hole between floor joists
for the blower box.
5-1/4"
14"
a
b
c
Attach the floor boot to the blower box with the included screws.
Slide the blower into the hole
cut in step "a". Attach with four
screws.
The screws
attach to either
of these pairs of
holes. Use the
upper pair for
thick flooring, the
lower pair for
thin flooring.
Attach the starter ring to the fireplace following the directions below (use the most convenient side
- 864TRV has only one opening on the right side).
Bend the tabs on the bottom of
the starter ring up to lock it in
place.
1/4" Nutdriver
Remove and discard the
cover plate.
Starter Ring