Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
3
Note: Power venting of direct vent fireplaces
may result in the reduction of efficiencies by
as much as ten percent. Consider this in
making any venting and heating decisions in
any installation application.
%seicneiciffE
sledoM
saGlarutaNenaporP
4P
ydaetS
etatS
EUFA4P
ydaetS
etatS
EUFA
03VDLPM 855636856646
53VDLPM 065636265636
04VDLPM 857646757656
54VDLPM 857656066646
htiwsledoMcinortcelEdnAtlovilliM
evlaVsaGdetaludoM-yllaunaM
saGlarutaNsaGenaporP
.oNledoM
tupnI
etar
)H/UTB(
.oNledoM
tupnI
etar
)H/UTB(
DLPMV03
000,31
ot
000,01
DLPMV03
005,11
ot
000,9
DLPMV53
000,91
ot
000,51
DLPMV53
000,81
ot
000,41
04VDLPM
000,52
ot
005,81
04VDLPM
005,12
ot
005,61
54VDLPM
000,62
ot
02000,
54VDLPM
000,52
ot
000,91
Table 1
ledoM
.oN
ezisecifirO
noitavelE
teeF
)sretem(
.taN.porP
03VDLPM "070.0
16#
)"930.0(
0054-0
)2731-0(
53VDLPM
54#
)"280.0(
"840.0
04VDLPM
14#
)"690.0(
45#
)"550.0(
54VDLPM
04#
)"890.0(
35#
)"5950.0(
Cet appareil peut être installé dans un
maison préfabriquée (É.-U. seulement)
ou mobile déjà installée à demeure si
les réglements locaux le permettent.
Cet appareil doit être utilisé uniquement
avec les types de gaz indiqués sur la
plaque signalétique. Ne pas l'utiliser
avec d'autres gaz sauf si un kit de con-
version certifié est installé.
Do not use these appliances if any part has been
under water. Immediately call a qualified, pro-
fessional service technician to inspect the ap-
pliance and to replace any parts of the control
system and any gas control which have been
under water.
Ne pas se servir de cet appareil s'il a été plongé
dans l'eau, complètement ou en partie. Appeler
un technicien qualifié pour inspecter l'appareil et
remplacer toute partie du système de contrôle et
toute commande qui ont été plongés dans l'eau.
This appliance may be installed in an af-
termarket permanently located, manufac-
tured home (USA only) or mobile home,
where not prohibited by local codes. This
appliance is only for use with the type of
gas indicated on the rating plate. This ap-
pliance is not convertible for use with other
gases, unless a certified kit is used.
Installations at Altitudes of 0 to 4500 ft.-
Units are tested and approved for elevations
of 0 to 4500 feet (0 to 1372 meters).
Installations at Altitudes above 4500 ft.-
For elevations above 4500 feet (1372
meters), install the unit according to the
regulations of the local authorities having
jurisdiction and, in the USA, the latest edition
of the National Fuel Gas Code (ANSI Z223.1)
or, in Canada, the latest edition of the
CAN1-B149.1 and .2 codes.
Table 1
shows the units' gas orifice size for
the elevations indicated.
These appliances must be isolated from the
gas supply piping system (by closing their
individual manual shut-off valve) during any
pressure testing of the gas supply piping sys-
tem at test pressures equal to or less than 1/2
psig (3.5 kPa).
These appliances and their individual shut-off
valves must be disconnected from the gas
supply piping system during any pressure
testing of that system at pressures in excess of
1/2 psig (3.5 kPa).
These appliances must not be connected to a
chimney or flue serving a separate solid fuel
burning appliance.
These heater rated appliances are intended
for use as supplemental heaters only. Using
these appliances as a primary heat source
may void the manufacturers warranty.
Carbon Monoxide Poisoning: Early signs of
carbon monoxide poisoning are similar to
the flu with headaches, dizziness and/or
nausea. If you have these signs, obtain fresh
air immediately. Turn off the gas supply to
the appliance and have it serviced by a
qualified professional, as it may not be op-
erating correctly.
All Models -
Maximum manifold pressure is 3.5 in. w.c.
(0.87 kPa) for natural gas and 10 in. w.c.
(2.49 kPa) for LP/Propane gas.
Provide adequate clearances around air open-
ings and adequate accessibility clearance for
service and proper operation. Never obstruct
the front openings of the appliance.
These appliances are designed to operate on
natural or propane gas only.
Millivolt And Electronic Models -
Millivolt and Electronic models come standard
with the manually-modulated gas valve; flame
appearance and heat output can be controlled at
the gas valve.
Input of millivolt and electronic models is
shown in the following table:
The millivolt appliances are manually controlled
and feature a spark ignitor (piezo) that allows the
appliance's pilot gas to be lit without the use of
matches or batteries. This system provides
continued service in the event of a power outage.
Test gage connections are provided on the
front of the millivolt and electronic gas control
valve (identified IN for the inlet and OUT for the
manifold side). A 1/8" NPT test gage connec-
tion is provided at the inlet and outlet side of
the electronic gas control valve.
Minimum inlet gas pressure to these appli-
ances is 5.0 inches water column (1.24 kPa)
for natural gas and 11 inches water column
(2.74 kPa) for propane for the purpose of input
adjustment.
Maximum inlet gas supply pressure to these
appliances is 10.5 inches water column (2.61
kPa) for natural gas and 13.0 inches water
column (3.23 kPa) for propane.