Filter
Top Products
32
OPERATION OF THE SYSTEM WTC 600 LP / MP
Service Handbook 08.2004
3.4.2.4 Programming
To start the programming, the covered
pushbutton (15/1) to the left of the “TIME OF
DAY” pushbutton (15/2) is to be pressed (a
circular indentation can be felt under the front
foil).The changing of the flashing positions is
carried out with the “ADVANCE” pushbutton
(15/3).
If a different adjustment than the
factory-setting is required, enter
and acknowledge by pressing
“MANUAL REGEN” (15/4).
Figure 15 XP Controller
2
1
43
When pressed continuously, the number values run through in double digits from the current
value to 99; by briefly pressing the pushbutton, the indication changes upward by the value 1.
Moving on to the next enter position is done by pressing the pushbutton mentioned in the 2nd
column in Table 17.
TIME OF DAY 1. Sets the time
2. Starts the programming of time steps
ADVANCE 1. For changing of parameters during proggramming
2. Calls up the diagnosis (see Table 24) - press for 10 sec
MANUAL REGEN 1. Activates a manual regeneration
2. Runs step by step through the regeneration steps
Covered pushbutton Left of the „TIME OF DAY“ pushbutton. Starts the programming.
Table 16 Input, preliminary filter control
Position Indication Description
At the media filter:
1 Covered pushbutton 0. 2 00 Media filter back-washing at 02.00 (minutes)
2 Covered pushbutton 0. 2 00 Media filter back-washing at 02.00
(full hours)
At the activated carbon filter
1 Covered pushbutton 0. 2 30 Backwashing of activated carbonfilter at
02.30 (minutes)
2 Covered pushbutton 0. 2 30 Backwashing of activated carbonfilter at
02.30 (full hours)
At both filters
3 Covered pushbutton FF01 Time interval (in days) between 2 backwa
shings; FF01 means one backwashing per
day
4 Covered pushbutton 200.0 Without function
5 Covered pushbutton 200.0 Without function
Table 17 Programming table
1)
for sand filter and activated carbon filter
NOTE