Filter
Top Products
Smocking
Machine setting _
(_) Pattern
(_) LED display
® Foot F: Satin stitch foot
Set the thread tension dial at 1-3, and stitch length at
3-4, sew straight lines 1 cm (3/8") apart across the
area to be smocked.
Knot the needle and bobbin threads along one edge.
Pull the bobbin threads and distribute gathers evenly.
Sew lines of the decorative pattern between the
straight seams. Pull out the gathering stitches.
(_) 1 cm (3/8")
1
Fagoting
Machine setting
O Pattern
(_) LED display
® Foot
41 42
F: Satin stitch foot
Fold under 1.5 cm (1/2") on each fabric edge and
press. Pin the two edges to a piece of paper 0.3 cm
(1/8") apart.
Sew guiding the fabric so the needle catches the
folded edge on each side.
Peel off the paper from fabrics.
Q ® ®
41 42
Cross Stitch
•Machine setting
O Pattern
(_) LED display
® Foot
49
F: Satin stitch foot
You can make an embroidery design with this cross
stitch pattern in a half time it would take by hand.
NOTES:
The pattern size can be reduced by pressing
Down (-) key in the stitch width adjusting mode.
• If you press the auto lock button before starting to
sew, the machine will sew one unit of the pattern
and stop automatically.
1
70