Filter
Top Products
Threading the Machine
Threading the machine
O Spool
(_) Spool holder
(_ Presser foot lifter
[] Raise the presser foot.
Press the needle Up/Down button twice to bring
the take-up lever to its highest position.
Draw the end of the thread with your left hand and
hook around the upper thread guide while holding
the thread at the spool with your right hand. Pass
the thread down into the slot.
(_ Upper thread guide
(_ Slot
[] Draw the end of the thread down around the thread
guide plate and draw it up to the left.
Make sure the tread slips in between the tension
disks.
(_ Thread guide plate
(_ Tension disks
[] Firmly draw up the thread up to the take-up lever,
and down into the eye of the thread take-up lever
from the right to left.
(_) Thread take-up lever
[] Pass the thread in the lower thread guide from the
right,
(_ Lower thread guide
[_ Slip the thread in the needle bar thread guide on
the left.
(_ Needle bar thread guide
NOTE"
Refer to page 26 for the automatic needle threader.
[]
[]
[]
[]
g][]
24