Filter
Top Products
Heatilator • RAVE4013I-C • 2293-900 Rev. C • 8/1264
Figure 16.4 SLP Series Vent Components
13 in.
(330 mm)
15 in.
(381 mm)
8-1/8 in.
(206 mm)
10-7/8 in.
276 mm
10-1/2 in.
267 mm
3°
87°
Effective Length
5-3/4 to 8-3/8 in.
146 to 213 mm
5-1/2 in.
140 mm
8-3/8 in.
213 mm
SLP-HRC-SS
SLP-HRC-ZC-SS
HORIZONTAL TERMINATION CAP
SLP-TRAP
Horizontal Termination Cap
15-1/8 in.
(384 mm)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm)
the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a
DVP-HSM-B will be required.
Heat
Shield
Term Cap
Minimum
Effective Length
Maximum
Effective Length
Trap1
3-1/8 in. 4-3/4 in.
79 mm 121 mm
Trap2
5-1/4 in. 9-1/4 in.
133 mm 235 mm
8 in.
(203 mm)
12 in.
(305 mm)
Max
Effective
Length
CAUTION: THE SLP-HRC-SS AND SLP-HRC-ZC-SS
TERMINATION CAPS ARE NOT APPROVED FOR
USE WITH PROPANE (LP) FUEL. May lead to ele-
vated glass temperature that may cause tempered
glass breakage.
SLP90
SL-2DVP
DVP-FBHT
DVP-FBHT
7 IN.
178 mm
15-1/2 IN.
394 mm
12 IN.
305 mm