Filter
Top Products
Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. F • 8/1164
A. Remove Fixed Glass Assembly
See Section 14G.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
14
14
Appliance Setup
E. Lava Rock/Teco-Sil and Glowing Ember
Placement
Prepare Electric Ember Bed and Lava Rock. The elec-
tric ember bed must be prepared before the logs are set
up. See Figure 14.1.
Start by applying the glass ember rock (Teco-Sil) to the
base pan as shown in Figure 14.2.
Figure 14.1 Teco-Sil
Figure 14.2 Teco-Sil Placement
Place a thin layer and follow the pattern on the base pan
as shown in Figure 14.3.
Figure 14.3 Teco-Sil Placement
Apply lava rock. The lava rock should cover the remain-
ing base pan area. See Figure 14.4. Do not put lava rock
on top of the glass ember rock (Teco-Sil) .
Figure 14.4 Lava Rock Placement
Turn on the electric ember lights and paint the glass em-
ber rock (Teco-Sil) to the desired darkness. See Figure
14.5.
Figure 14.5 Painting Teco-Sil