Filter
Top Products
Heat & Glo • 6000TRS-CE • 2049-900 Rev. Q • 2/118
Heat & Glo direct fl ue gas fi replaces are designed to
operate with all combustion air siphoned from outside
of the building and all exhaust gases expelled to the
outside.
The information contained in this Installers Guide,
unless noted otherwise, applies to all models and gas
control systems.
Gas fi replace diagrams, including the dimensions, are
shown in this section.
This gas fi replace and its components are tested and
safe when installed in accordance with this Installers
Guide. Report to your dealer any parts damaged in
shipment, particularly the condition of the glass. Do
not install any unit with damaged, incomplete, or
substitute parts.
The flue system components and trim doors are
shipped in separate packages. The gas logs are
packaged separately and must be fi eld installed.
Read all of the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefi t. Failure to follow these instructions
will void the owner’s warranty and may present
a fi re hazard.
The Heat & Glo Fireplace Products, Inc. Warranty
will be voided by, and Heat & Glo Fireplace Products,
Inc. disclaims any responsibility for, the following
actions:
• Installation of any damaged fi replace or fl ue system
component.
• Modifi cation of the fi replace or direct fl ue system.
• Installation other than as instructed by Heat & Glo
Fireplace Products, Inc.
• Improper positioning of the gas logs or the glass
door.
• Installation and/or use of any component part not
manufactured and approved by Heat & Glo Fireplace
Products, Inc., not withstanding any independent
testing laboratory or other party approval of such
component part or accessory.
ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE
HAZARD.
Introducing the
Heat & Glo
Gas Fireplaces
Pre-installation
Preparation
2
Getting
Started