Filter
Top Products
Mighty Mule 352
13
Determining the Mounting Position
of the Post Bracket Assembly and the Gate Bracket
Step 5
With the gate in the open position (up to 110º from its closed position), and the opener fully retracted,
adjust the post bracket assembly and gate bracket until the opener is level. While holding the opener
level, use C-clamps to temporarily keep the post bracket assembly and gate bracket in their respective
positions on the fence post and gate.
Step 3
Insert the
3
/8" x 2" bolt
through the center hole
of the post brackets
and post pivot bracket
as shown. Fasten a
3
/8" washer,
3
/8" lock
washer and
3
/8" nut on
the end of the bolt. DO
NOT overtighten the nut
because the post pivot
bracket will have to be
adjusted later.
Step 4
Attach post bracket assembly and gate bracket to the opener with the clevis pins and bushings. Secure the
clevis pins with hairpin clips.
3/8" x 2" Bolt
3/8" Nut
Post Pivot Bracket
Post Bracket
Post Bracket
3/8" Lock Washer
Post Bracket Assembly
3/8" Washer
NOTE: The following steps are
intended for pull-to-open gate
installations. If you are mounting
your opener on a push-to-
open gate (e.g., a gate on a
sloped driveway) you will need
to purchase a Push To Open
bracket (FM148) (see Accessory
catalog). Also, see Push-to-
Open Installation beginning on
page 36.
Clevis Pin
Hairpin Clip
Post Bracket Assembly
Bushing
Rear Mount
Opener
Clevis Pin
Hairpin Clip
Bushing
Gate Bracket
Front Mount
Level Opener
Fence Post
Gate In Open Position
LEVEL horizontal cross member
Post Bracket Assembly
Gate Bracket