Filter
Top Products
Product SPecificationS
Product SPecificationS
SS-CPC90-150 www.goodmanmfg.com 29
roof curb inStallation (cont.)
Curb installations must comply with local codes and should follow the
established guidelines of the National Roong Contractors Association.
Proper unit installation requires that the roof curb be rmly and permanently
attached to the roof structure. Check for adequate fastening method prior to
setting the unit on the curb.
Full perimeter roof curbs are available from the factory and are shipped
unassembled. The installing contractor is responsible for eld assembly,
squaring, leveling, and mounting on the roof structure. All required hardware
necessary for the assembly of the sheet metal curb is included in the curb
accessory package.
• Determine sucient structural support before locating and mounting the
curb and package unit.
• Duct-work must be constructed using industry guidelines. The duct-work
must be placed into the roof curb before mounting the package unit. Our
full perimeter curbs include duct connection frames to be assembled with
the curb. Cantilevered-type curbs are not available from the factory.
• Contractor furnishes curb insulation, cant strips,
ashing, and general roong material.
• Support curbs on parallel sides with roof members.
To prevent damage to the unit, the roof members
cannot penetrate supply and return duct openings.
Note: The unit and curb accessories are designed to
allow vertical duct installation before unit placement.
Duct installation after unit placement is not
recommended.
See the manual shipped with the roof curb for
assembly and installation instructions.
toP View
3-d View
15⅜ x 31⅛
Supply Opening
14⅛ x 38⅜
Return Opening
92¼
53¼
14
1⅜
¾
14
1⅜
Power and low-Voltage block locationS
Power Wiring
Thermostat
Wiring