Stovax Studio 22 Indoor Fireplace User Manual


  Open as PDF
of 39
 
2
AR2119
3.2 To completely remove the glass front:
• Openthedooratarightangletothefire
• Liftthedoorverticallyoffitshingesandplacetoone
side, Diagram 3
3
AR2137
• Refitinreverseorder
• Refitinreverseorder
4. GLASS WINDOW
4.1 Remove the two clips and brackets from either side of the
frame, Diagram 4
4
AR1864
• Lifttheglassclearfromthelockbracketatthetopofthe
frame and slide out
1. GENERAL
1.1 All main components can be replaced without removing the
appliance from its installation. It is essential that the gas
supply to the appliance is turned off at the isolation device
before proceeding further.
1.2 • DISCONNECT BATTERIES BEFORE SERVICING THE
APPLIANCE
1.3 Removal of Flue
If, for any reason, the flue has to be removed from the
appliance, the seal must be replaced in the inner spigot.
1.4 Access to the controls is restricted and the whole of the
control assembly is to be removed as one unit. Refer to
Section 7 below
2. DECORATIVE FRAME
2.1 The same method is used to remove each frame.
• Lifttheframeupwardsoffthefoursupportbrackets,
Diagram 1
1
AR2136
NOTE: THE STEEL FRAME IS HEAVY. TAKE CARE WHEN
LIFTING
3. WINDOW FRAME ASSEMBLY
3.1 Using the allen key provided to release the upper and lower
catches on the right side of the door:
• Slidetheallenkeyintothegapbetweenthedoorand
frame and locate the catch of the upper lock
• PushtheallenkeyDOWN
• Slidetheallenkeyintothegapandlocatethelowerlock
• PushtheallenkeyUP
• Openthedooroutwards
When closing the door ensure the door catches are fully
engaged.
31
SERVICING INSTRUCTIONS
REPLACING PARTS
 previous next