Stovax Studio 22 Indoor Fireplace User Manual


  Open as PDF
of 39
 
25
INSTALLATION INSTRUCTIONS
INSTALLATION
9.3 Remove the screw from the pressure test point
• Connectasuitablepressuregaugetothetestpoint
located on the inlet fitting
• Refittheburner
• Turnonthegas
• Lighttheappliancetocheckforleaks
• Turnoffthegas
• Removetheburner
• Disconnectthepressuretestpoint
• Replacethetestpointscrew
9.4 • Replacetheaccesspanelinthebaseoftheappliance
with the two screws, Diagram 34, Arrow B
• Replacetherearairbaffle,securingeachsidewiththe
two screws, Diagram 34 Arrow A
34
AR2116
A
A
B
• Puttheburnertrayinplaceandtightenthefourscrews
• Replacethevermiculitebackpanel
• Refitthetwosidepanels
• Refittheclipstotheupperinsidetoholdthesidepanels
in place, Diagram 35
• Refitthefrontvermiculitepanelinfrontoftheburner
35
AR2127
Vermiculite side panel
10. ARRANGEMENT OF FUEL BED
ADVICE ON HANDLING AND DISPOSAL OF FIRE
CERAMICS
The fuel effect and side panels in this appliance are made
from Refractory Ceramic Fibre (RCF), a material which is
commonly used for this application.
Protective clothing is not required when handling these
articles, but we recommend you follow normal hygiene
rules of not smoking, eating or drinking in the work area
and always wash your hands before eating or drinking.
To ensure that the release of RCF fibres are kept to a
minimum, during installation and servicing a HEPA filtered
vacuum is recommended to remove any dust accumulated
in and around the appliance before and after working on it.
Whenservicingtheapplianceitisrecommendedthatthe
replaced items are not broken up, but are sealed within
heavy duty polythene bags and labelled as RCF waste.
RCFwasteisclassedasstable,non-reactivehazardouswaste
and may be disposed of at a licensed landfill site.
Excessive exposure to these materials may cause temporary
irritation to eyes, skin and respiratory tract; wash hands
thoroughly after handling the material.
After cleaning the fire or replacing parts, carefully
re-assembletheceramiccomponents.WHEN THE EMBERS
ARE PLACED ON THE BURNER IT IS IMPORTANT THEY
DO NOT COVER ANY PORTS!
The fuel bed is made up of embers and 6 logs, identifiable
by moulded letters:
10.1 Place the embers around the burner holes as shown in
Diagram 36. Do not cover any of the holes.
36
AR2120
10.2 PlaceLogAontothetwostudsontheburnerskin,
Diagram 37, with charred effect of the log facing
forward.
 previous next