Filter
Top Products
TIMER MODE – (appliance must be in standby mode; pilot ignited): The Timer mode is normally
programmed to have two (2) Periods: P1 and P2. Between these two (2) periods, a lower
operating temperature (or pilot only) can be set.
Note: that between those periods, if the thermostat is set to a certain minimum temp (example
58°F (14.5°C)), then the unit will modulate to maintain that temp.
For to operate as a thermostat, TEMP must be set at 40°F (4.5°C) or higher.
If the setting is decreased to --, the motor will turn the valve to the standby position in
the moon times and await the next burner cycle.
NOTE: The display shows the set temperature every 30 seconds.
Changing the Mode of Operation
Briey pressing the SET button changes the mode of operation in the following order:
and back to
NOTE: MAN mode can also be reached by pressing either the (up arrow) or the (down arrow).
“MAN” Mode - Manual Flame Height Adjustment
1. Press (up arrow) to turn on the main burner.
2. Press (up arrow) to increase the ame height.
3. Press (down arrow) to decrease the ame height or to go to pilot standby position.
NOTE: While pressing either button a symbol indicating transmission appears on the display. The receiver
conrms transmission with an acoustic signal.
Setting the Temperature
1. Select either the MODE or the MODE by briey pressing the SET button.
2. Hold the SET button until the TEMP display ashes.
3. Set the desired temperature with (up arrow) or (down arrow). NOTE: 4.5°C/40°F is the min.
temperature setting.
NOTE: If you would like the Nighttime Setback temperature control to turn off, decrease the nighttime
temperature until [---] appears on the display.
Setting the Timer
1. Select Timer mode by briey pressing the SET button.
2. Press and hold the SET button until “TIMER” is displayed on the lower right hand side.
3. Press and hold the SET button until the P1 (sun symbol) and the time display ashes. Set the hour
by pressing the (up arrow) and set the minutes by pressing the (down arrow).
4. Briey press SET button for the next burner cycle time. Example: P1 (moon symbol) continue
through P2 (sun symbol) and P2 (moon symbol).
5. Once all four (4) times are set, press OFF or simply wait to complete programming.
9
Operating Instructions