Filter
Top Products
23
Dutchwest Direct Vent / Natural Vent Gas Heater
30001935
Operation
Your First Fire
Read these instructions carefully and familiarize your-
self with the burner controls. Locate the pilot assembly,
Figure 45. Follow the lighting instructions on Page 25
exactly.
During the first fire, it is not unusual to smell some
odor associated with new logs, paint and metal being
heated. Odors should dissipate within an hour or so,
however, you can open a window to provide fresh air to
alleviate the condition.
Pilot and Burner Inspection
Each time you light your heater check that the pilot
flame and burner flame patterns are as shown in Figure
47. If flame patterns are incorrect, turn the heater off.
Contact your dealer or a qualified gas technician for as-
sistance. Do not operate the heater until the pilot flame
is correct.
Follow regular maintenance procedures as described
on Page 30.
ST769
Dutchwest
pilot location
5/15/03 djt
Pilot Assembly
ST769
Fig. 45 Pilot assembly location.
Flame & Temperature Adjustment
For stoves equipped with HI/LO valves, flame adjust-
ment is accomplished by rotating the HI/LO adjustment
knob located near the center of the gas control valve.
(Fig. 46)
Turn
counterclockwise
to decrease
flame height
Turn clockwise
to increase
flame height
HV102
Honeywell hi/lo knob
4/5/99 djt
Fig. 46 Flame adjustment knob for Honeywell valve.
Flame Characteristics
It is important to periodically perform a visual check
of the pilot and the burner flames. Compare them to
Figure 47. If any of the flames appear abnormal, call a
service person.
CO105c
Pilot flame
4/10/00 djt
LG142
Stardance
Install logs 2
12/11/00 djt
CO106c
Red
Glow
LG143
Fig. 47 Correct pilot and burner flame patterns.