Filter
Top Products
13
Dutchwest Direct Vent / Natural Vent Gas Heater
30001935
Install the Optional Fan
If you are installing the optional convection Fan Kit
#2767 (FK26), continue here. If you are not installing a
Fan Kit, go to Page 14, Venting System Assembly.
1. The fan kit includes a Blower Assembly and a Rheo
-
stat Assembly, connected by a cable. (Fig. 12) The
Blower Assembly mounts to the bottom rear of the
stove, and the Rheostat mounts to the valve cov-
erplate. The assembly includes a ‘snapstat’ which
automatically turns the fan On (or Off) above (or
below) approximately 109˚. The Rheostat also pro-
vides a range of fan speed settings from Off (which
overrides the snapstat function) to High. Unpack and
inspect the Blower assembly. Confirm that the fan
spins freely.
WARNING
This appliance is equipped with a three-prong
(grounded) plug for your protection against shock
hazard and should be plugged directly into a prop-
erly grounded three-prong receptacle. Do not cut or
remove the grounding prong from this plug.
ST473
Fan parts
#2767 FK26
9/29/00
Snapstat
Bracket
Snapstat/
Extension
Assembly
Not Used on RF
Models
Not Used
on
Dutchwest
Blower
Assembly
Connect to PC Board on
RF Models Only
Not Used
on RF
Models
Rheostat
Assembly
ST473
Fig. 12 Fan kit components.
2. Remove the rear skirt insert panel at the bottom of
the Rear Skirt (Fig. 13) and fasten the blower as-
sembly to the firebox back with the two Phillips pan-
head bolts originally installed in the firebox back. (‘1’,
Fig. 14)
3. Attach the snapstat assembly to the snapstat brack-
et with two sheet-metal screws. (‘2’, Fig. 14) Attach
the snapstat bracket to the stove with a hex-head
bolt passing through the bracket and into the stove
base. (‘3’, Fig. 14)
4. The rheostat control switch attaches to the left side
of the valve bracket at the front of the stove.
• Remove retaining nut from shaft of rheostat. (if
preinstalled)
• Insert the rheostat through the hole in the back
of the left side of the valve bracket, aligning the
locator pin with the smaller hole in that bracket.
• Thread the retaining nut onto the shaft of the
rheostat, tightening with a wrench. Do not over-
tighten.
• Attach the control knob to the rheostat shaft.
• Use the wire tie to secure the fan and rheostat
wire harnesses together.
ST757
Dutchwest
rear skirt insert
5/15/03 djt
Rear Skirt
Sheet Metal
Screws
Rear Skirt Insert
ST757
Fig. 13 Remove rear skirt insert.
ST314
Fk26ce
attach fan
1/24/00
Star Washer
Sheet Metal Screws
Phillips
Pan
Head
Bolts
Star
Washer
Snapstat
1/4” - 20
Hex Bolt
Snapstat
Bracket
ST314
1
2
3
Fig. 14 Attach the fan assembly and the snapstat.
ST758
Dutchwest
attach rheostat
5/15/03 djt
Rheostat
Retaining Collar
Rheostat Knob
ST758
Fig. 15 Attach the fan rheostat.