Filter
Top Products
33CS450-01
Carrier
Select YES if the
thermostat should be
Light Activated.
Select NO to allow only
Time Period Programming
(Section 6).
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
PROGRAM
Press
A light sensor is provided on the thermostat for light activation. If the
thermostat is set up to be light activated, the thermostat will enter
Occupied 1 and blink the Occupied 1 icon when a light source is
detected. When the thermostat is set up to be light activated, the time
period programming for each day should be set to OFF (Section 6).
The thermostat must be in Program On mode for light activation to
have any effect. Page 17.3 explains how to adjust the light sensitivity
for this type of operation.
Page 17.2
Setting up the Thermostat for
Light Activated Operation
Setting up the Thermostat for
Light Activated Operation
42
Setup
Light Sensor
The Light Sensor is located on
the top of the thermostat.
NOTE: Light activation does not work in Holiday mode (Section 21).
17
PROGRAM
MODE
MODE
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
YES
NO