Filter
Top Products
Possible REMOTE scenarios:
1) Arm the alarm system in your building after you have left for
the day.
3) Turn on your interior lights while you’re closed.
2) Turn off your sign lights after arriving home.
Page 14.7
Internet/Phone Control of the
Programmable Output
Internet/Phone Control of the
Programmable Output
To operate a MISC output using Internet/phone-based operation,
program advanced setup step #30 for Aux . (below) This terminal is
especially useful for devices that can be energized via the Internet.
Telephone control may also be available when the thermostat is
connected to the Internet.
Press the UP button three
times to set the
programmable output
for Aux (web-based
operation).
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
PROGRAM
Press
PROGRAM
MODE
MODE
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Setup
3 i
NC
NO
Programmable Output Polarity:
NC = Normally Closed to operate
when programmed to be OFF
through the phone or internet.
NO = Normally Open to operate
when programmed to be ON
through the phone or internet.
MODE
Press
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
OFF Time = Temp = Aux
I8:88
88
14
AUX
Setup
30
Carrier