Filter
Top Products
Carrier
Page 15.4
Averaging the Remote Sensor (RS1) with
the Thermostat Sensor
Averaging the Remote Sensor (RS1) with
the Thermostat Sensor
If step #37 is set to control to the remote sensor, the thermostat will
ignore the reading of its internal temperature sensor and only display
the temperature reading from the remote sensor. The degree icon on
the thermostat will blink once per second to indicate that a remote
sensor reading is being displayed.
If step #38 is set to ON (see below), the thermostat will average its
internal sensor with the wired temperature sensor connected to RS1.
I
The temperature displayed will be the
average of the thermostat’s internal sensor and the remote (RS1)
sensor(s).
f multiple remote temperature sensors are installed on RS1, they will
automatically average together.
Remote
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
PROGRAM
Press
Optional Remote Sensor
Operation:
ON = Averages thermostat
sensor with Remote
Sensor 1.
OFF = Does not average
thermostat sensor
with Remote Sensor 1.
On
Off
OFF
Setup
38
PROGRAM
MODE
MODE
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
15