Filter
Top Products
6
CONTENTS BEFORE USE
SEWING
UTILITY STITCHES MAINTENANCE
SEWING CHART
PATTERNS
(PROGRAMMED IN
MACHINE)
STANDARD ACCESSORIES
2 Cleaning brush X59476-051
3 Screwdriver (large) X55467-051
4 Screwdriver (small) X55468-051
5 Bobbin (3) SA155 XA3812-051
6 Spool cap (small) 130013-053
7 Spool cap (large) 130012-053
8 Eyelet punch 135793-001
9 Spool net* XA5523-050
10 Extra spool pin* XA3336-051
11 Spool felt X57045-051
12 Disc-shaped screwdriver XA2005-051
13 Foot controller XA3931-051
14 Hard case XA2482-051
15 Twin needle X59296-001
No. Part Name
Part Code
U.S.A. Others
* Always use a thread net with metallic threads.
* When using special threads which quickly wind
off the thread spool, place a
net over the spool before
sewing.
* The extra spool pin, which
is provided as an accessory,
should be attached to the
end of the bobbin winder
shaft during use.
Note (For U.S.A. only)
Foot controller: Model N5V
This foot controller can be used on this machine
model PC-2800.
OPTIONAL ACCESSORIES
123
456
789
10 11 12
13 14 15
12
34
1– Walking foot*
Parts code: SA140, X81065-002
2– Side cutter*
Parts code: X81028-001
3– Stitch guide foot “P”
Parts code: SA160, XA8839-002
4– Quilting foot
Parts code: XA4322-001
* When using the walking foot, refer to page 23.
* When using the side cutter, refer to page 38.
Needle set
1 75/11: 2 pcs
90/14: 2 pcs X58358-001
90/14 Ball point needle
(gold colored)
(for stretch fabrics): 2 pcs