Filter
Top Products
Basic Stitching 79
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e
Start sewing.
• For details, refer to "Starting to sew" (page
49).
• For details on sewing reverse/reinforcement
stitches, refer to "Securing the stitching" (page
51).
f
When sewing is finished, cut the thread.
• For details, refer to "Cutting the thread" (page
52).
■ Changing the needle position
The needle position used as the baseline is
different for the straight stitch (left needle
position) and the straight stitch (center needle
position).
a Straight stitch (left needle position)
b Straight stitch (center needle position)
When the stitch width of the straight stitch (left
needle position) is set to its standard setting
(0.0 mm), the distance from the needle position to
the right side of the presser foot is 12 mm
(1/2 inch). If the stitch width is changed (between
0 and 7.0 mm (1/4 inch)), the needle position will
also change. By changing the stitch width and
sewing with the right side of the presser foot
aligned with the edge of the fabric, a seam
allowance can be sewn with a fixed width.
a Stitch width
b Distance from the needle position to the right side
of the presser foot
c 12.0 mm (1/2 inch)
d 10.0 mm (3/8 inch)
e 6.5 mm (1/4 inch)
f 5.0 mm (3/16 inch)
• For details, refer to "Adjusting the stitch width"
(page 56).
12
0.0 2.0 5.5 7.0
345
6
1
2
SE-BrotherE_sgml.book Page 79 Monday, June 30, 2003 3:44 PM