Filter
Top Products
146
EMBROIDERY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
• For details, refer to "Resewing" (page 157).
• For details, refer to "Adjusting the layout"
(page 154).
Memo
z When an LCD button has dashed lines
around it (i.e.: ), that button cannot be
selected.
Selecting characters
Specify the characters for embroidery. A maximum of
25 continuous characters from the same group can be
combined.
Memo
z When "The pattern is too large for the
embroidery frame." is displayed, no more
characters can be input.
z Characters from different groups (sans serif
and serif, etc.) cannot be combined.
a
Select the type of characters.
b
Select the characters for embroidery.
If a character is pressed by mistake, press .
Example: Welcome
Press when you want to change the
color character by character in
character embroidery. Since the
sewing machine stops at the end of
each character, the upper thread is
changed as you sew.
The needle progresses one color or
one stitch (if pressed continuously, 9
stitches to 20 stitches) at a time and
changes the position for starting the
embroidery. This is used when a
specific color is not sewn or when
restarting the sewing machine after
power has been turned off in the
middle of the operation.
Back one color Forward one
color
Back one stitch Forward one
stitch
The position of the pattern within the
embroidery frame can be checked,
and the size and angle can be
changed.
Switch between uppercase/lowercase
Switch among large/medium/small sizes
SE-BrotherE_sgml.book Page 146 Monday, June 30, 2003 3:44 PM