Filter
Top Products
29
BAS-311E.311EL.326E.326EL
Chapter 3. Assembly
3. Work clamp lifter mechanism
1. Attach the presser plate q to the presser bar lifter lever rubber w, and insert them from the bottom of the arm. Insert
the parts r linked to the plunger e from the top of the arm, and fit them on link shaft C t, link B y, and the presser
plate q.
2. Fit the snap pins u on both ends of link shaft C t.
3. Insert link shaft A i into the machine, and pass it through the washer o and link A !0.
4. Fit the snap pins !1 on both sides of link shaft A i and outside the washer o.
5. Attach the presser solenoid !2 to the top of the arm so as to cover the plunger e. Secure link shaft A i using the set
screw !4 so that link B y is centered in the bush !3.
6. Slide the presser solenoid !5 until it has reached 19.0 mm from the end of the arm, where the plunger e easily moves,
and tighten the screw !6.
7. Attach the spring !7 to link shaft B !8 and the pin !9.
8. Hang the rod @0 on the shoulder screw @1, and insert the former into link shaft B @2, and secure it using the snap pins @3.
9. Attach the rubber cap @4.
!6
!4
!5
@0
!9
@1
@4
@3
@2
!8
e
!4
!7
@0
w
u
q
e
y
t
o
!1
!2
i
!0
!3
!7
@0
!1
i
79.0mm
!7
!3
r