Filter
Top Products
Troubleshooting 263
7
——
——————————————————————————————————————————————————
—
————————————————————————————————
The pattern could not be saved
because the memory is full.
Delete some patterns.
The memory capacity of the USB
media has been exceeded.
There is too much data in either the
machine or the USB media.
was touched in the
embroidering screen.
Touch to return to the
embroidering settings screen. The
previous embroidery in the
The selected pattern is going to be
deleted because was
touched.
The image is going to be deleted. The machine was turned off while
sewing, then turned on again.
Touch to return the
machine to the condition (pattern
position and number of stitches)
when it was turned off. Follow the
procedure described in “Resume
Embroidering After Turning Off the
Machine” on page 110 to align the
needle position and sew the
remainder of the pattern.
was touched while thread
colors were being changed.
A saved combined pattern is being
rotated in the embroidering
settings screen.
The thread picker did not operate
correctly.
Remove the thread entangled on
the thread picker.