Brother 884-T09 Sewing Machine User Manual


 
Using the Optional Cap Frame 231
7
——
——————————————————————————————————————————————————
————————————————————————————————
4
Securely clamp the mounting bracket onto
the mounting surface by tightening the
thumb screw.
1 Mounting bracket
2 Mounting surface
3 Tighten thumb screw
Memo
If there is a gap between the clamping pad
of the thumb screw and the mounting
surface, insert the included pad as shown
below.
1 Mounting bracket
2 Mounting surface (worktable, desk, etc.)
3 Pad
4 Thumb screw
5
Check that there is no looseness.
If there is looseness, mount the mounting jig
onto the mounting surface again.
Note
Be sure that the mounting bracket is
securely clamped onto the mounting
surface and that the thumb screw is firmly
tightened.
Do not attach the mounting jig to an
unstable surface (flexible, bent or warped).
Be careful that the mounting jig does not
fall when it is removed.
6
Adjust the size of the mounting jig according
to the type of cap being embroidered.
1 Low Profile (Low fitting)
2 Standard type (Pro style)
For the standard type
Using a Phillips screwdriver, turn the four
screws (two on the left and two on the right) at
the inside of the mounting jig one turn to loosen
them.
1 Screws
2 Phillips screwdriver
Note
Do not remove any of the four screws (two
on the left and two on the right);
otherwise, they may be lost. Only turn the
screws to slightly loosen them.