Filter
Top Products
8 en | Safety MIC612 Thermal Camera
F.01U.249.416 | 2.0 | 2012.09 Installation Manual Bosch Security Systems, Inc.
8. Do not point the camera at the sun. Bosch Security Systems will not be liable for any
damage to cameras that have been pointed directly at the sun.
9. Do not back drive the pan or tilt axis of the camera. Doing so will damage the motor drive
gear chain and will invalidate the warranty.
1.5 EC Directives
The MIC612 complies with the following EC directives:
– EMC Direct (89/336/EC as amended)
– Machinery Directive (98/37/EC)
– LV Directive (73/23/EC)
– RoHS (Restriction of Hazardous Substances) 2002/95/EC
– WEEE (Waste Electrical and Electronic Equipment) 200/96/EC
Environmental statement - This symbol means that electronic and electrical appliances
which have reached the end of their working life must be collected and disposed of separately
from household waste material. Separate collecting systems are usually in place for electronic
and electrical products. Please dispose of these units at an environmentally compatible
recycling facility, per European Directive 2002/96/EC.
Bosch has a strong commitment towards the environment. The camera was designed and
manufactured with high-quality material and components that can be recycled and reused.
1.6 Important Notices
Cold Start-ups - If camera is powered up in extremely cold temperature (for example, -
40°C),please allow 30 minutes warm-up after powering camera prior to operation. In some
cases,camera may require soft reset (Aux ON 911) or a power cycle before usable video is
available.
Ventilation - The camera is a completely sealed unit and requires no special consideration as
regards to ventilation.
Object and liquid entry - With the exception of the base connector, the camera can be
exposed to non corrosive liquids without damage. Never push objects into the base connector
as this may damage the connection pins and prevent the camera operating correctly.
Lightning - For added protection during a lightning storm, or when leaving this unit
unattended and unused for long periods, unplug the unit from the wall outlet and disconnect
the cable system. This will prevent damage to the unit from lightning and power line surges.
Power sources - Operate the unit only from the type of power source indicated on the label.
Before proceeding, disconnect the power from the cable to be installed into the camera.
– For external power supplied units, use only the recommended or approved power
supplies.
– For limited power source units, this power source must comply with EN60950.
Substitutions may damage the unit or cause fire or shock.
NOTICE!
This device is intended for use in public areas only.
U.S. federal law strictly prohibits surreptitious recording of oral communications.
NOTICE!
This equipment contains electrical or electronic components that must be recycled properly in
order to comply with Directive 2002/96/EC of the European Union regarding the disposal of
waste electrical and electronic equipment (WEEE). Contact your local supplier for procedures
for recycling this equipment.