Filter
Top Products
32 en | Getting Started MIC612 Thermal Camera
F.01U.249.416 | 2.0 | 2012.09 Installation Manual Bosch Security Systems, Inc.
5.3.2 Navigating the On-Screen Display (OSD) Menus
The OSD menus provide access to the programmable settings of the camera. The OSD
displays only the submenus that are applicable to a particular MIC configuration. Some menu
items (indicated as (L)) are locked and require a system password to use. Menu items marked
with an asterisk (*) are default factory settings, unless otherwise noted.
To navigate the OSD menus:
1. Use the joystick to highlight a menu item.
2. Press either the Focus or the Iris key to open a menu item.
3. Follow the on-screen instructions.
Note: To select the Exit Menu item from anywhere in the current menu, use the Zoom
command.
5.3.3 Keyboard Commands, Bosch Protocol
Keyboard control commands are composed of a sequence of three (3) inputs with the
following convention: 1) a Function key + 2) a Command number key(s) + 3) the Enter key.
– Depending on the type of keyboard, the control function keys are labeled:
ON or AUX ON
OFF or AUX OFF
SET or SET SHOT
SHOT or SHOW SHOT
– Command numbers range from 1 to 999. See Section A Keyboard Commands By Number
for a complete list of keyboard commands for Bosch protocol.
–The Enter key can also be labeled with the ∞ symbol.
For example, the keyboard command to make the MIC612 pan 360º continuously is:
ON-1-ENTER (Press the ON key, then press the number 1 key, and then press ENTER.)
5.3.4 Keyboard Commands, Pelco Protocol
Pelco control commands are composed of a sequence of two (2) keyboard inputs with the
following convention: 1) a Command Number and 2) a Function key input.
The MIC612 uses the PRESET command key to save and recall presets (pre-positions) 1
through 99.
NOTICE!
After 4.5 minutes of inactivity, the OSD menu times out and exits without warning. Some
unsaved settings in the current menu can be lost.
NOTICE!
The convention used for control key commands in this manual is ON, OFF, SET, and SHOT.
Refer to your keyboard manual for the key naming conventions.
NOTICE!
To save a preset, enter the desired number and hold the PRESET key for approximately two
(2) seconds. To recall a preset, enter the desired preset number (or command) and
momentarily press and release the PRESET key.