Whirlpool ACQ254XF0 Air Conditioner User Manual


 
The unit turns on and off too much, or does not cool room
Check if . . .
The air conditioner is not
properly sized for your
room.
Then . . .
Check the cooling capabilities of your room air conditioner. Room air conditioners are
not designed to cool multiple rooms.
The filter is dirty or
obstructed by debris.
Clean the filter. See page 14.
The inside evaporator and Clean the inside evaporator and outside condenser coils. See page 18.
outside condenser coils are
dirty or obstructed by debris.
There is excessive heat or
Use a fan to exhaust heat or moisture from the room. Try not to use heat-producing
moisture (open container
appliances during the hottest part of the day.
cooking, showers, etc.)
in the room.
The louvers are blocked.
Install the air conditioner in a location where the louvers are free from curtains, blinds,
furniture, etc.
The temperature of the
Allow extra time for the air conditioner to cool off a very hot room.
room you are trying to cool
is extremely hot.
Windows or doors to the
Close all windows and doors.
outside are open.
I
The Exhaust Vent Control is
set to OPEN.
I
Set the Exhaust Vent Control to CLOSED for maximum cooling.
The Thermostat is not at a
cool enough setting.
The air conditioner is
:
installed on the sunny side
of your house.
The outside temperature is
below 65°F (18%).
Adjust the Thermostat to a cooler setting by turning the knob clockwise. Turn Fan
Control to QUICK COMFORT.
Install your air conditioner in a more shaded window.
Do not try to operate your air conditioner when the outside temperature is below
65°F (18°C).
Water drips from cabinet into your house
conditioner should slope
slightly downward toward
on a carpenter’s
level
[l
.O degrees] for models with a sliding side curtain
and
1 full
bubble [2.5 degrees] for models with a filler board) to ensure proper drainage. See
the Installation Instructions for an illustration.
Reposition
or shim the cabinet as
21