Filter
Top Products
High-Wall Type
Owner’s Manual
–31–
Toshiba
10. POWER SAVING MODE
• The power saving mode saves energy by limiting the maximum current which will effect heating or cooling
capacity that the unit can generate.
Push button during operation.
• The air conditioner enters power saving mode.
• appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push button again.
• disappears.
NOTE
• Power saving mode consumes less energy, but may not heat/cool the room as much as normal mode.
(The maximum current is limited to approximately 75% (factory default) of the normal mode.)
• This Value can be adjusted between 50% to 99%.
• Even when operation start/stop, operation mode change, or power reset is performed during the power
saving mode, the power saving mode is retained until the next operation.
Change power saving mode setting
1 Push button for at least four
seconds when the air conditioner is not
working.
• and numbers flash.
2 Push (left side of button) to select
an indoor unit to be set.
• Each time you push the button, unit numbers
change as follows:
The fan of the selected unit runs and the louvers start
swinging.
3 Push TIME buttons to adjust the
power-save setting.
• Each push of the button changes the power level
by 1% within the range from 100% to 50%.
* The factory default is 75%.
4 Push button.
5 Push button to complete the setting
1
3
4
5
2
UNIT No.
1-1
UNIT No.
1-2
UNIT No.
1-3
UNIT No.
1-4
Setting of power level in power
saving mode
31-EN
+001111052101_00Ta.book Page 31 Friday, November 20, 2009 1:13 PM