Filter
Top Products
High-Wall Type
Owner’s Manual
–25–
Toshiba
NOTE
Auto Changeover
• When in Auto Mode, the unit selects the
operating mode (cooling, heating or fan only)
based on the user selected set point
temperature.
• If the Auto mode is uncomfortable, you can
select the desired conditions manually.
Cooling
• If there is a demand for cooling, unit will start
approximately 1 minute after mode is selected.
Heating
• If there is a demand for heating, unit will start
approximately 3 to 5 minutes after the mode is
selected.
• After the heating operation has stopped, FAN
may continue to run for approx. 30 seconds.
• When the room temperature reaches the set
temperature and the outdoor unit stops, the
indoor unit fan runs at ultra low speed and the
outdoor unit fan runs at low speed.
During defrost operation, the fan stops so that
cool air is not discharged.
(“ ” Pre-heat is displayed.)
When restarting the operation after stop
• When attempting to restart the unit immediately
after it was stopped, the unit can not start for
approx. 3 minutes this is to protect the
compressor.
25-EN
+001111052101_00Ta.book Page 25 Friday, November 20, 2009 1:13 PM