Filter
Top Products
High-Wall Type
Owner’s Manual
–15–
Toshiba
Automatic operation
(auto changeover)
Start
1 ON/OFF button ( )
Press this button to start the air conditioner.
2 MODE button
Select A.
3 Set temperature button ( )
Set the desired temperature.
4 FAN button
Select one of LOW , LOW
+
,
MED , MED
+
,
HIGH .
• The OPERATION lamp (green) on the
display panel of the indoor unit illuminates.
The operating mode is selected in accordance
with the room temperature and operation starts
after approximately 3 minutes.
• If the “A” mode is uncomfortable, you can select
the desired conditions manually.
Stop
ON/OFF button ( )
Press this button again to stop the air conditioner.
Timer operation
Use the wired remote controller for timer setting if it
is also in use.
ON timer and OFF timer
Setting TIMER
1 ON/OFF TIMER button ( or )
Press the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and flashes
along with ON/OFF timer display.
Set the timer to the desired time.
Each press of the TIMER button changes the time in
ten minute steps.
Pressing the TIMER button continually changes the
time in one hour step.
2 SET button
Press the SET button to set the timer.
The timer is indicated and the timer starts.
Cancelling TIMER
3 CLR button
Press the CLR button to cancel the timer setting.
TEMP
2
4
3
1
TEMP
CLR
SLEEP
SET
TEMP
3
2
1
ON
OFF
SET
SET
CLR
CLR
15-EN
+001111052101_00Ta.book Page 15 Friday, November 20, 2009 1:13 PM