Filter
Top Products
High-Wall Type
Owner’s Manual
–14–
Toshiba
EN
6-5. WIRELESS REMOTE
CONTROL
Cooling/heating/fan only
operation
Start
1 ON/OFF button ( )
Press this button to start the air conditioner.
2 MODE button
Select Cool , Heat , or Fan only .
3 Set temperature button ( )
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4 FAN button
Select one of LOW , LOW
+
,
MED , MED
+
,
HIGH .
• The OPERATION lamp (green) on the
display panel of the indoor unit illumintates. And
operation starts after approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start
immediately.)
• The : Fan only mode does not control
temperature.
• Fan speed is the same as
HIGH .
Therefore, perform only steps
1, 2 and 4 to
select this mode.
Stop
ON/OFF button ( )
Press this button again to stop the air conditioner.
Dry operation
Start
1 ON/OFF button ( )
Press this button to start the air conditioner.
2 MODE button
Select DRY .
3 Set temperature button ( )
Set the desired temperature.
• The fan speed display indicates
• The OPERATION lamp (green) on the
display panel of the indoor unit lights, and
operation starts after approximately 3 minutes.
Stop
ON/OFF button ( )
Press this button again to stop the air conditioner.
TEMP
2
4
3
1
TEMP
TEMP
2
3
1
TEMP
14-EN
+001111052101_00Ta.book Page 14 Friday, November 20, 2009 1:13 PM