Filter
Top Products
High-Wall Type
Owner’s Manual
–24–
Toshiba
EN
7-1. CORRECT USAGE
• When you use the air conditioner for the first time or when you change the setting, follow the steps below.
Settings are saved in memory and are displayed anytime the unit is turned on by pushing the
button.
Preparation
• When the circuit breaker is turned on, the partition lines are displayed on the remote control.
* After the circuit breaker is turned on, the remote control does not accept any commands for approx. 1 minute, this is
not a failure.
REQUIREMENT
• When you re-power the air conditioner after it has not been used for a long period, turn on the circuit
breaker at least 12 hours before starting the air conditioner.
Start
1 Push button.
The operation lamp illuminates, and the operation
starts.
2 Select an operation mode with the “ ”
button.
One push of the button, and the display changes in
the order shown below.
3 Select fan speed with “ ” button.
One push of the button, and the display changes in
the order shown below.
• When fan speed is “ AUTO”, fan speed is
adjusted based on difference between set point
and room temperature.
• In heating operation, if the room temperature is not
heated sufficiently with volume “ LOW”
operation, select “ MED.” or “ HIGH”
operation.
• The temperature sensor detects the return air
temperature at the indoor unit, which differs from
the room temperature depending on the
installation condition.
• Set point is a target of room temperature.
• ( “AUTO” is not selectable in the FAN
mode.)
4 Select the set point temperature by pushing
the “TEMP. ” or “TEMP. ” button.
Stop
Push button.
The operation lamp goes off, and the operation
stops.
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
1
3
2
4
AUTO HEAT DRY COOL FAN
.
AUTO
HIGH
MED.
LOW
24-EN
+001111052101_00Ta.book Page 24 Friday, November 20, 2009 1:13 PM