High-Wall Type
Owner’s Manual
–21–
Toshiba
7. WIRED REMOTE CONTROL
This remote control can control the operation of up to 8 indoor units.
The remote control has two sections: The display section and the operation section.
Display section
In the display below all the icons are shown. When the unit is in
operation, only relevant icons will be displayed.
• When the circuit breaker is turned on the first time,
flashes on the display part of the remote control.
• While this display is flashing, the model is being automatically
confirmed.
Wait till display has disappeared to use the remote
control.
1 SETTING display
Displayed during setup of the timer etc..
2 Operation mode
The selected operation mode is displayed.
3 Error display
Displayed while the protective device works or a error
occurs.
4 Timer display
When a malfunction occurs, an error code is
displayed.
5 Timer Mode display
Displays the timer mode.
6 Filter display
, reminder to clean the air filter.
7 TEST run display
Displayed during a test run.
8 Louver position display
Displays louver position.
9 Swing display
Displayed during up/down movement of the louver.
10
Set temperature display
The selected set temp. is displayed.
11
Remote control sensor display
Displayed while the sensor of the remote control is
used.
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
Display
section
Operation
section
Pertition line
2
14
18
5
7
3
1
4
6
11
9
8
13
12
10
17
16
15
21-EN
+001111052101_00Ta.book Page 21 Friday, November 20, 2009 1:13 PM