High-Wall Type
Owner’s Manual
–26–
Toshiba
EN
7-2. TIMER OPERATION
• Three timer modes are available: (Setting of up to 168 hours is enabled.)
Timer operation
Set
1 Push TIMER SET button.
The timer mode changes with every push of the
button.
• and timer display flashes.
2 Push to select “set time”.
• With every push of button, the set time
increases by 0.5 hr (30 minutes).
• When setting a time more than 24 hours for timer
operation, timer can be set in increments of 1 hr.
• The maximum set time is 168hr (7 days).
• The remote control displays the set time with time
(between 0.5 and 23.5 hours) (*
1
) or number of
days and time (24 hours or more) (*
2
) as shown
below.
• With every push of button, the set time
decreases by 0.5 hr (30 minutes) (0.5 - 23.5 hours)
or 1 hr (24 - 168 hours).
Example of remote control display
• In the case of 23.5 hours (*
1
)
• In the case of 34 hours (*
2
)
3 Push button.
• display disappears and timer time display
goes on, and or display flashes.
(When ON timer is activated, timer time, ON timer
are displayed and other displays
disappear.)
4 Cancel of timer operation
Push button.
Timer display disappears.
NOTE
• When the operation stops after the timer
reached the preset time, the Repeat OFF timer
resumes the operation by pushing
button and stops the operation after the time of
the timer has reached the set time.
• When you push while the OFF timer
function of the air conditioner is active, the
indication of the timer function disappears and
then appears again after about 5 seconds.
This is due to normal processing of the remote
control.
OFF timer : The unit stops when the set time is reached.
Repeat OFF timer : The unit stops daily when the set time is reached.
ON timer : The unit starts when the set time is reached.
1
3
2
4
(OFF timer) (ON timer)(Repeat OFF timer)
Not display
OFF OFF
ON
shows 1 day (24 hours).
shows 10 hours. (Total 34 hours)
Number of days Time
26-EN
+001111052101_00Ta.book Page 26 Friday, November 20, 2009 1:13 PM