Filter
Top Products
High-Wall Type
Owner’s Manual
–27–
Toshiba
7-3. LOUVER DIRECTION
For best cooling and heating performance, adjust the louvers appropriately. In cooling the louvers should
be directed so that the air discharge is horizontal. In heating they should be directed to discharge towards
the floor to prevent layers of hot air forming close to the ceiling.
CAUTION
Direct the louvers horizontally in cooling.
If the louvers are pointed downward in cooling, condensation may form on the louvers and then drop to
the floor.
Set louver direction
1 Push during operation.
The louver direction changes with every push of the
button.
In HEAT operation
Direct the louver downward.
In COOL/DRY operation
Direct the louver horizontally.
In FAN operation
Select a desired wind direction.
Start swing operation
1 Push , set the louver direction to the
lowest position, and then push
again.
SWING is displayed and the louvers swing
automatically.
Display during swinging
Stop swing operation
1 Push at a desired position while the
louver is swinging.
• When is pushed after that, the louver
direction can be set again from the highest
position.
• In COOL/DRY mode, the louver does not stop as
it directs downward. If stopping the louver as it
directs downward during swing operation, it stops
after moving to the third position from the highest
position.
Display when swinging is stopped
1
Unit select button
Initial setup
Initial setup
Initial setup
Repeat
FAN/HEAT
operation
COOL/DRY
operation
27-EN
+001111052101_00Ta.book Page 27 Friday, November 20, 2009 1:13 PM