Filter
Top Products
Setup Menu Teledyne API – Model T300/T300M CO Analyzer
126
5.9.3.4. AUTOMATIC CALIBRATION OF THE ANALOG OUTPUTS
To calibrate the outputs as a group with the AOUTS CALIBRATION command, select
the ANALOG I/O CONFIGURATION submenu (see Figure 5-3) then press:
IMPORTANT
IMPACT ON READINGS OR DATA
Before performing this procedure, make sure that the AUTO CAL for each
analog output is enabled. (See Section 5.9.3.3).
IMPORTANT
IMPACT ON READINGS OR DATA
Manual calibration should be used for any analog output set for a 0.1V
output range or in cases where the outputs must be closely matched to
the characteristics of the recording device.
06864B DCN6314